CAUTION : If your product is completely weak, the red LED will not light during the charge.
In this case, after approximately 15 mn of charge, place for one second the magnetic key close to the
orange mark situated on the front of your collar (See. Diagram1). Then, the red light indicator will light
to indicate you that your battery is charging.
- Once the battery is fully charged, the red light indicator goes out to indicate that your product is
completely recharged.
- Disconnect the collar from the charger.
- Disconnect the charger from the socket.
- Replace the protection tab making sure it is positioned correctly.
- Press strongly to ensure it is engaged.
CAUTION : if your protection tab is badly repositioned or badly engaged, the waterproofness of your
collar will be compromised and you risk to damage your product.
Switching on the collar
Briefly place (for less than 1 second) the magnetic key close to the orange mark placed in front of the
collar.
1, 2, 3 or 4 short sound beeps are emitted (according to the chosen mode) and indicate(s) that the collar
has been switched on.
In the factory, the collar's mode is positioned on mode 2 (beep sounds + light stimulations).
Switching off the collar
Briefly place (for less than 1 second) the magnetic key close to the orange mark placed in front of the
collar.
One long sound beep indicates that the collar has been switched off.
Changing operating modes
In the factory, the collar's mode is set to mode 2 (beep sounds + light stimulations).
To change the collar's mode, when switching on the collar you need to approach and keep the magnetic
key in contact with the orange mark.
A series of sound beeps is emitted (from 1 to 4 beeps) indicating the selected mode.
Keep the magnetic key in contact with the orange mark to run through modes.
Remove the magnetic key when you have reached the mode you wish.
The collar will memorize your selected mode.
Next time you will switch on the collar, your collar will be turned on to the last mode you previously
selected.
Gb - 13