Setting The Barking Detection Sensitivity - Num'axes Iki Pulse Manual De Instrucciones

The chart below indicates how your collar operates according to the mode you have selected:
Number of sound beeps
heard when switching modes
1
2
3
4

Setting the barking detection sensitivity

Your dog's barking is detected by the contact points which sense the vibrations of his vocal cords.
Setting the barking detection sensitivity is a very important preliminary operation. In fact, this setting
determines the correct operation of the product.
It ensures detection of any barking but helps avoid unnecessary detection. The detection must
therefore be sufficiently sensitive but not overly sensitive. In the factory, detection sensitivity is set on
the medium position (medium sensitivity).
To adapt the detection sensitivity to the barking strength of your dog, you should proceed as follows:
- Remove the protection tab situated at the back of the collar (See. Diagram 3).
- Carefully turn the setting screw according to the sensitivity you wish using the supplied small plastic
screwdriver (See. Diagram 3).
CAUTION: the adjustment system has a
stop for the minimum sensitivity and a stop
for the maximum
delicately and without forcing with the
supplied screwdriver.
- Replace the protection tab making sure it
is positioned correctly.
- Press strongly to ensure that it is engaged.
CAUTION: if the protection tab is badly
repositioned or badly engaged, the
waterproofness of your collar will be
compromised and you risk to damage your
product.
sensitivity. Turn
Mode
1 Beep sound only
2 Beep sound + low stimulation
3 Beep sound + higher stimulation
4 Beep sound + increasing stimulations
Minimum sensitivity
small
plastic
screwdriver
Diagram. 3
Protection tab
Gb - 14
Operation
Maximum sensitivity
Medium sensitivity