FLAEM Lella Manual De Instrucciones página 10

• Only use the device in dust-free environments; otherwise, therapy may be compromised.
• The casing of this unit is not protected against the penetration of liquids. Do not wash the device under running
water or submerge in water. Keep away from splashing water or other liquids.
• Do not expose the device to high temperatures.
• Do not put the device near heat sources, direct sunlight, or in hot environments.
• Do not obstruct or insert any objects in the filter or in its housing.
• Do not obstruct the air vents placed on both sides of the unit.
• During use, always place the unit on a firm surface clear of obstacles.
• Check that there is no material obstructing the air vents before each use.
• Do not place any objects inside the air vents.
• The average duration provided for compressor ranges is: F400: 400 hours, F700: 700 hours, F1000: 1000 hours,
F2000: 2000 hours.
• Repairs must be performed by authorized personnel only. Any unauthorized repairs will void the warranty and
may pose a safety hazard for the user.
WARNING: Do not modify this equipment without authorization of the manufacturer
• The Manufacturer, the Retailer and the Importer are responsible for the safety, reliability and performance of the
device only if: a) the device is used in accordance with the operating instructions b) the electrical system of the
premises where the device is used is in compliance with current laws.
• Interactions: The materials used that come into contact with medications have been tested with a wide range of
medications. However, due to the variety and continuous evolution of medication, the possibility of a chemical
interaction cannot be excluded. We recommend that once the medication has been opened you should use it as
soon as possible and avoid prolonged contact of the medication with the nebulizer.
• The manufacturer should be contacted for reporting problems and/or unexpected events related to device
operation.
INSTRUCTIONS FOR USE
RF6 BASIC NEBULISER
2
Before each use, the nebuliser and accessories should be cleaned according to the instructions in the
section "CLEANING, SANITIZATION, DISINFECTION AND STERILIZATION". A personal use of the nebuliser
and its accessories is recommended in order to avoid any risks of infection.
1. Plug the power cord (A6) into the socket (A5) and plug the power cord into a power socket corresponding to the
voltage of the unit. This must be positioned so that it is not difficult to make the disconnection from the mains.
2. Open the nebuliser by turning the upper part (C1.3) counterclockwise.
3. Pour the medication prescribed by the physician into the lower part (C1.1). Close
the nebuliser by turning the upper part (C1.3) clockwise.
4. Connect accessories as indicated in the "Connection diagram" on the cover.
5. Sit comfortably holding the nebuliser in your hand, place the mouthpiece onto
your mouth or alternatively use the nose piece or mask. Should you opt for the
mask accessory, place it on your face as shown in the picture (with or without
using the elasticated strap).
The cap (C1.4) provided with the nebuliser RF6 Basic
6. Turn on the device using the switch (A1) and then breathe in and exhale deeply.
7. When the treatment is finished, shut off the device and unplug the power cord.
WARNING: If after the therapy session moisture accumulates in the tube (B), remove the tube from the nebulizer
and dry it using the device's compressor fan; this operation will prevent mold from forming inside the tube.
"standard mode"
for optimum delivery
and minimum waste of
medication
makes it possible to deliver the medication in 2 modes:
2
"high speed mode"
for a quicker treatment
10