Safety Instructions; Machine Components - HSM shredstar S5 Instrucciones De Servicio

Ocultar thumbs Ver también para shredstar S5:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 19
1 Proper use, warranty
The shredder is to be used exclusively for
shredding small quantities of paper. Please
make sure that the paper does not contain any
paperclips. Paperclips can damage the cutting
device.
The warranty period for the document shredder
is 2 years. This warranty excludes wear, dam-
age due to improper handling, natural deprecia-
tion, and actions taken by third parties.

2 Safety instructions

• Read all instructions before start-up of the
paper shredder. Save these instructions for
later use.
• Follow all warnings and instructions marked
on the product!
Risk of injury!
Do not reach into the paper feed
slot.
Risk of injury by pulling in!
Keep long hair, loose articles of
clothing, ties, scarves, jewellery
etc. away from feed opening.
Material with the tendency to form
loops, e.g. tapes, strapping mate-
rial, etc. must not be shredded.
Risk of combustion!
Do not use cleaning agents or
pressurized air sprays which con-
tain infl ammable substances, as
they could ignite.
Keep paper shredder out of the
reach of children. This shredder
should be operated only with an
operator in attendance.
02/2011
Switch the shredder off if it is dam-
aged or not working correctly or
before relocating or cleaning it and
disconnect it from the mains.
Service work may only be carried
out by HSM Customer Service or
by the service technicians of our
contractual partners.
• Make sure no liquid is spilled on or in the paper
shredder.
• Make sure the mains plug is easily accessi-
ble.
• Before plugging in the mains plug, check
that the voltage and frequency of your local
mains supply correspond to those stated on
the type plate.
• The shredder is for indoor use only and
must not be placed near a heater or other
heat source. The ventilation slots must not
be blocked or covered and they must be at
a distance of at least 4" (10 cm) away from
walls or furniture.

3 Machine components

3
2
1
1
Cut material container
2
Feed opening
3
Slider switch
4
Cutting head
4
7

Publicidad

Tabla de contenido
loading

Tabla de contenido