Important Safety Notice - ELICA Arietta DKI001MX 36 Guía De Instalación Y Del Usuario

READ AND SAVE ThESE INSTRUCTIONS
CAUTION:
For general ventilating use only. Do Not Use To Exhaust hazardous or Explosive materials, And Vapors.
CAUTION:
DURING ThE hOOD INSTALLATION, ThE PEOPLE INSTALLING ThE hOOD mUST wEAR PROTECTION GLOVES
AGAINTS ShARP EDGES.
wARNING
TO REDUCE ThE RISK OF FIRE, ELECTRIC ShOCK OR INJURY TO PERSONS, OBSERVE ThE FOLLOwING:
•
Use this unit only in the manner intended by the manufacturer. If you have questions, contact the
manufacturer.
•
Before servicing or cleaning the unit, switch power off at the service panel and lock the service disconnecting
means to prevent power from being switched on accidentally. If the service disconnecting means cannot be
locked, securely fasten a prominent warning device, such as a tag, to the service panel.
•
Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable
codes & standards, including Fire-rated construction.
•
Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel
burning equipment to prevent back- drafting. Follow the heating equipment manufacturers guideline and safety
standards such as those published by the National Fire Protection Association (NFPA), the American Society
for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and the local code authorities.
•
When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.
•
Ducted fans must always be vented to the outdoors.
•
Do not make alterations to the original wiring.
•
Do not attempt to repair or replace any part of your hood unless it is specifically recommended in this manual.
All other servicing should be referred to a qualified technician.
•
Avoid using food products that produce flames under the range hood.
CAUTION:
To reduce risk of fire and to properly exhaust air, be sure to duct air outside - do not vent exhaust air into spaces within
walls, ceilings, attics, crawl spaces, or garages.
Automatically operated device - to reduce risk of injury disconnect from power supply before servicing.
wARNING
TO REDUCE ThE RISK OF FIRE, USE ONLY mETAL DUCT wORK.
Install this hood in accordance with all requirements specified.
wARNING
TO REDUCE ThE RISK OF FIRE OR ELECTRIC ShOCK, DO NOT USE ThIS hOOD wITh ANY EXTERNAL SO-
LIDSTATE SPEED CONTROL DEVICE.
5