Dexter 20VCIS3-190BL.1 Manual De Instrucciones página 372

FR FR
2. SAFETY INSTRUCTIONS
ES ES
all angles and depths of cut.
PT PT
B. Check the operation of the lower guard spring. If the guard and
the spring are not operating properly, they must be serviced
IT IT
before use. Lower guard may operate sluggishly due to damaged
EL EL
parts, gummy deposits, or a build-up of debris.
C. The lower guard may be retracted manually only for special
PL PL
cuts such as "plunge cuts" and "compound cuts". Raise the lower
guard by the retracting handle and as soon as the blade enters
RU RU
the material, the lower guard must be released. For all other
sawing, the lower guard should operate automatically.
UA KZ
D. Always observe that the lower guard is covering the blade
before placing the saw down on bench or floor. An unprotected,
KZ UA
coasting blade will cause the saw to walk backwards, cutting whatever
is in its path. Be aware of the time it takes for the blade to stop after
RO RO
switch is released.
BR BR
ADDITIONAL SPECIFIC SAFETY INSTRUCTIONS FOR CIRCULAR SAW
EN
EN
WARNING: Do not use abrasive wheels or blades.
Do not use water feed attachments.
A. Use clamps or another practical way to secure and support the
workpiece to a stable platform. Holding the work by hand or against
your body leaves it unstable and may lead to loss of control.
B. Keep your body positioned to either side of the blade, but not in line
with the saw blade. KICKBACK could cause the saw to jump backwards.
C. Air vents often cover moving parts and should be avoided. Loose clothes,
jewelry or long hair can be caught in moving parts.
D. Avoid cutting nails. Inspect for and remove all nails from lumber before
cutting.
WARNING: Some dust created by power sanding, sawing, grinding,
drilling, and other construction activities contains chemicals known to
372