PULOX PO-300 Manual De Instrucciones página 54

Appendix
Appendix 1
State
Low voltage alarm
SpO alarm
2
Pulse rate alarm
Probe error alarm
Appendix 2
Guidance and manufacture's declaration – electromagnetic emissions-
Guidance and manufacture's declaration – electromagnetic emission
The CMS50E Pulse Oximeter is intended for use in the electromagnetic environment specified below.
The customer of the user of the CMS50E Pulse Oximeter should assure that it is used in such and
environment.
Emission test
RF emissions
CISPR 11
RF emission
CISPR 11
Guidance and manufacture's declaration – electromagnetic immunity –
Guidance and manufacture's declaration – electromagnetic immunity
The CMS50E Pulse Oximeter is intended for use in the electromagnetic environment specified below.
The customer or the user of CMS50E Pulse Oximeter should assure that it is used in such an
environment.
Immunity test
Electrostatic discharge
(ESD)
IEC 61000-4-2
Power frequency
(50Hz) magnetic field
IEC 61000-4-8
Guidance and manufacture's declaration – electromagnetic immunity –
for EQUIPMENT and SYSTEMS that are not LIFE-SUPPORTING
Guidance and manufacture's declaration – electromagnetic immunity
The CMS50E Pulse Oximeter is intended for use in the electromagnetic environment specified below.
The customer or the user of CMS50E Pulse Oximeter should assure that it is used in such an
environment.
IEC 60601 test
Immunity test
level
Alarm condition delay
60 s
1 s
1 s
16 ms
Guidance and manufacture's declaration
for all EQUIPMENT and SYSTEMS
Compliance Electromagnetic environment – guidance
The CMS50E Pulse Oximeter uses RF energy only for its
internal function. Therefore, its RF emissions are very low
Group 1
and are not likely to cause any interference in nearby
electronic equipment.
The CMS50E Pulse Oximeter is suitable for use in all
establishments, including domestic establishments and those
Class B
directly connected to the public low-voltage power supply
network that supplies buildings used for domestic purposes.
for all EQUIPMENT and SYSTEMS
IEC 60601 test Compliance
level level
8 kV contact 8 kV contact
15 kV air 15 kV air
30A/m 30A/m
Compliance level Electromagnetic environment - guidance
Alarm signal generation delay
5 ms
5 ms
5 ms
5 ms
Electromagnetic environment - guidance
Floors should be wood, concrete or
ceramic tile. If floor are covered with
synthetic material, the relative humidity
should be at least 30%. the manufacturer
may recommend the ESD precautionary
procedures to user.
Power frequency magnetic fields should be
at levels characteristic of a typical location
in a typical commercial or hospital
environment.