Initial Use - LIVARNO LUX 14117201L Instrucciones De Montaje, De Uso Y De Seguridad

Note: Carefully remove the protective film from
the lampshade .
7
Model 14117201L / 14117206L:
Remove the screws
connection housing
ing bracket at the back.
2
Use the slotted holes in the mounting bracket
intended for the screws
Now drill the fixing holes (approx. 6 mm,
depth approx. 30 mm). Be sure not to damage
the supply line.
Insert the dowels
1
Fasten the mounting bracket
provided screws
3
Feed the power cord (external)
protective tubes
20
Now connect the external lead of the light to
the mains cable (external)
nal block .
10
Also ensure to connect the correct coloured
wires (black or brown live wire = L symbol,
blue neutral wire = N symbol).
Now connect the protective conductor (green-
yellow) to the marked ground terminal inside
the connection housing
Now use the screws
the mounting bracket
Loosen the lamp ring
Place the lampshade
and use the lamp ring to secure it in place
Use a clean, lint-free cloth when inserting the
lamp .
9
Screw the bulb
9
socket . Ensure that it is positioned correctly.
6
Model 14117301L / 14117306L:
Note: You will need a second person for the
installation.
Use the holes in the connection housing
which are intended for the screws
the drill holes.
Now drill the fixing holes (approx. 6 mm,
depth approx. 30 mm). Be sure not to damage
the supply line.
Insert the plugs
1
visible at the side of the
5
and remove the mount-
4
to mark the bores.
3
into the bores.
with the
2
.
through the
11
.
using the termi-
11
.
4
to fasten the light to
5
.
2
from the bulb socket
8
onto the bulb socket
7
clockwise into the bulb
4
, to mark
3
into the bores.
Mounting the light / Initial use
Insert the mains connection lead through the
opening in the connection housing
Feed the power cord (external)
protective tubes
Now connect the external lead of the light to
the mains cable (external)
nal block
10
Also ensure to connect the correct coloured
2
wires (black or brown live wire = L symbol,
blue neutral wire = N symbol).
Now connect the protective conductor (green-
yellow) to the marked ground terminal inside
the connection housing
Fasten the connection housing
provided screws
Screw the spacers
Use a clean, lint-free cloth when inserting the
lamp .
9
Screw the bulb
socket . Ensure that it is positioned correctly.
6
Check that all spacers
rubber sleeves
If necessary, place the rubber sleeves
the spacers
Place the lampshade
Position the lampshade
so that the spacer
the middle of the cover
. Remove the fixing screw
6
panel onto the washer
6 15
. Attach the panel
8
using the fixing screw
Reinsert the fuse or switch the circuit breaker
back on.
Your light is now ready to use.

Initial use

Use the wall switch to switch the light on or off.
through the
11
.
20
using the termi-
11
.
.
4
with the
4
.
3
into the base
13
clockwise into the bulb
9
are fitted with
19
.
18
.
19
onto the cover
7
with the cover
7
comes out of the hole in
13
.
15
and place the
17
.
16
to the lampshade
15
.
17
.
4
.
12
over
18
.
15
15
7
GB/IE 17