Helo RONDO Instrucciones De Uso E Instalación página 33

RA 19 – CONTROL
OK
RA 19 Controller Type 1601-19
Button functions:
While the controller is in standby mode (displays not lit) the clicking of the button will activate the
controller. When the controller is active, pressing this button will stop all functions and the controller
/ heater is disconnected.
The button is used to accept any changes in the settings and / or to move to the next setting /
O K
operational mode.
Increases the setting rate. Browsing of the rates can be speeded up by holding the button pressed
down.
Reduces the setting rate. Browsing of the rates can be speeded up by holding the button pressed
down.
Activates a relay on the circuit board. The heater has its own connector for the lighting controller,
voltage 230 VAC and the maximum power 100W. A led is activated next to the
Control panel when the light/s is/are on.
Operational times and
control settings:
Thermostatically controlled simmering level
4.5 kW unit is approx. 500 W
6.5 kW unit is approx. 700 W
9.6 kW unit is approx. 1000W
Sauna light control on / off
Stone space temperature display
Operational time display (full power)
Sauna room temperature display (requires installation of a sensor as an accessory)
Simmering mode on
Addition of the setting rate
Saving the setting rates
Connection of full power
Selection of the operational mode
Reduction of the setting rate
Activation of the controller
Operational time (full power)
Stone space temperature (full power)
Stone space temperature (simmering mode)
light button on the
0 – 2 hours
250 – 300°C
150 – 250°C
4