Helo RONDO Instrucciones De Uso E Instalación página 36

Setting of the heater on full power
When the heater is set on full power, the heater lid must always be opened!
Transfer from the simmering mode to full power is undertaken by holding down the control panel
OK button for about 3 seconds. Then the controller moves to the full power setting mode and the
flashing upper display shows the latest set stone space maximum temperature. When the display
is flashing the temperature of the stone space can be set to the desired rate by using the + and –
buttons. The setting range is 250°C – 300°C.
The change of the setting is stored in the memory by pressing the OK button or alternatively by
waiting for about 3 seconds and then the controller stores the change automatically and moves to
the next setting point.
If no change in the temperature is desired, the operation can be continued by pressing again the
OK button or alternatively by waiting for about 3 seconds and then the controller moves
automatically to the next setting point.
=
The heater is Press the OK
on the button and hold
simmering mode down for appr.
3 seconds.
Next the lower display shows the latest set sauna time by flashing. Also the sauna use time can
be controlled by using the + and – buttons as long as the display is flashing. The sauna use time
can be set to 0 – 2 hours. The setting is stored just like with the temperature either by using the OK
button or by waiting for about 3 seconds.
=
The stored sauna
time flashes on
the lower display.
OK
=
The saved stone
space temperature
flashes on the
upper display.
OK
=
The sauna time
can be changed
by the + and
buttons.
OK
=
The stone space
temperature can
be changed by +
and buttons.
=
Changed sauna Save the change
time by pressing the OK
button or wait for
appr. 3 seconds
= =
Changed stone Save the change
space temperature by pressing the
OK button or
wait for appr.
3 seconds.
OK
=
The heater goes
to full power mode
OK
7