Gas Connection - Angelo Po 1G1FAPG Manual De Uso

A variety of optional installation kits are available for
arranging appliances in banks:
G)"Bridge" installation kit

GAS CONNECTION

Important
Those authorised to carry out this opera-
tion must have experience acquired and
certified in the specific sector, must make
the connection to the proper standards,
and must comply with all the relevant regu-
lations and legislation. Once the connec-
tion has been made, before the appliance is
put into operation a general check must be
made to ensure there are no gas leaks.
To make the connection, connect the mains line to
the appliance's connection pipe, fitting a shut-off
tap (A), to allow the gas supply to be cut off when
necessary.
Important
The tap (A), not supplied with the appliance,
must be installed in an easily accessible
position and its status (on or off) must be
obvious at a glance.
CONVERSION OF THE GAS SUPPLY
The manufacturer has tested the appliance with its
own mains gas, identified by the sticker applied to
the nameplate.
If the type of gas to be connected is different from
that used for testing, proceed as follows.
1-Turn off the gas supply tap.
2 - Change the plate burner nozzle (see page 24).
3 - Change the plate burner pilot light nozzle ( see
page 25).
Important
The gas supply pipe must comply with the
national requirements in force and must be
periodically examined and replaced if
necessary.
A
- 19 -
G
IDM-39609202500.tif
A
IDM-39603610200.tif
IDM-39603610300.tif
IT
GB
DE
FR
ES
English