Conversion Of Gas Supply; Testing Of The Appliance - Angelo Po 0N0FT1G Manual De Uso

Caution - Warning
Before doing any work, cut off the mains elec-
tricity supply.
The manufacturer has tested the appliance
with its own mains gas, identifi ed by the sticker
applied to the nameplate.
If the type of gas to be connected is diff erent
from that used for testing, proceed as follows.
Turn off the gas supply tap (A).
1)
Disconnect the electricity supply.
2)
Replace the burner nozzle (see page 13).
3)
Replace the pilot light injector (see page14).
4)
Remove the sticker from the nameplate and
5)
apply the new one to identify the gas being
used.
Important
On completion of the operation, make sure
that there are no gas leaks or malfunctions.
GB
Important
Before it is put into service, the system must
be tested to check the operating conditions
of every single component and identify any
malfunctions. In this stage, it is important to
check that all health and safety requirements
have been complied with in full.
To test the system, make the following checks:
Turn on the gas supply tap and check that the
1)
connections are right;
Check that the mains gas is the same as that
2)
used for commissioning of the appliance,
and carry out the conversion procedure if
necessary (see page 11);
3269771_inst_GB

CONVERSION OF GAS SUPPLY

TESTING OF THE APPLIANCE

3)
4)
5)
6)
After testing, if necessary instruct the user in all
the skills necessary for putting the appliance into
operation in conditions of safety, in accordance
with legal requirements.
- 12 -
A
Check that the burner is switching on correctly
and its combustion;
Check that the safety thermocouple is working
correctly;
Check that there are no gas leaks;
Check that the nameplates specify the correct
gas for the country of use.
ENGLISH