Fault; Troubleshooting - Angelo Po 0N0FT1G Manual De Uso

The appliance has been tested before being put
into service.
The information provided below is intended to
assist in the identifi cation and correction of any
anomalies and malfunctions which might occur
during use.
The user can solve some of these problems him-
self, but for others specifi c technical knowledge
or skill is required, and so they must only be car-
ried out by qualifi ed staff with recognised experi-
ence acquired in the specifi c sector of operation.
Faults
Smell of gas
The pilot light does not
ignite
GB
The pilot light goes out.
The pilot light ignites but
the burner remains off .
The fl ame is yellow.
Burner control knob is stiff .
3269771_ut_GB

FAULT

TROUBLESHOOTING

For all requirements contact the agents or
the headquarters of Angelo Po which can be
found in the contacts section of the website
http://www.angelopo.com.
Causes
Occasional leak because fl ame
has gone out.
The spark ignition devices are
not working.
Air in pipelines due to long
period out of use.
The thermocouple has not
warmed up enough.
Burner dirty, heat exchange
pipes clogged, condensation
drips.
Gas control valve malfunction.
- 14 -
Important
Remedies
Turn off the gas supply tap and
ventilate the room
Check that the ignition devices
are in good working order.
Light by hand with a naked
Important
Contact the after-sales service.
Make more attempts to light
the fl ame.
Make more attempts to light
the fl ame.
Check the condition of the
thermostat and activate any
ignition enabling device.
Important
Contact the after-sales service.
Important
Contact the after-sales service.
light.
ENGLISH