Skoda BEA 630 001 Instrucciones De Montaje página 10

it is attached to a trailer. Towing couplings, mounted from the Škoda series or genuine
accessories portfolio, are not equipped with analogue input. For the above reason the
park distance control will not be deactivated after coupling of a trailer.
Advice
If there occurs an irregular false indication of an obstacle, it can be due to frost in the
sensors. Clean the sensors (not with pressure water).
Should there sound a special warning tone after the introductory tune immediately,
one of the sensors has been disconnected or damaged. The number of the faulty sen-
sor is indicated by the number of short beeps following after the warning tone:
1 beep
2 beeps
3 beeps
4 beeps
Spare sensors can be ordered under the ordering numbers:
BEA 700 001 01 – central sensors
BEA 700 001 02 – edge sensors
Warning
The capacity of the system to detect obstacles depends upon their material and
their shape!
The acoustic signalling during backing does not exempt the driver from respon-
sibility for damages inflicted when parking the vehicle and in similar mano-
euvres.
Therefore, before backing make sure that there is no obstacle of smaller size
behind your vehicle (e.g. a stone, a thin pillar, draught pole of a trailer etc.). Such
an obstacle could be located out of the sensed area.
edge sensor No. 1 (PIN 11, 23)
central sensor No. 2 (PIN 9, 21)
central sensor No. 3 (PIN 10, 22)
edge sensor No. 4 (PIN 12, 24)
GB