Lengthy Downtimes Of Appliance; Servicing - Angelo Po 0G1PE2 Manual De Uso

If the appliance is to be out of use for a lengthy pe-
riod, proceed as follows.
1 - Cut off the mains electricity supply using the ap-
pliance's master switch.
2 - Clean the appliance and the surrounding areas
thoroughly.
To ensure correct use of the appliance, the follow-
ing rules should be adopted.
– Use only the accessories recommended by the
constructor.
– Do not use the plate for cooking food directly
without a pan.
– Only use the appliance to heat pans.
– To save energy, use thick-base, flat pans
with a base slightly larger than the plate it-
IT IT
Keep the appliance at peak efficiency by carrying
GB GB
out the scheduled servicing procedures recom-
mended by the constructor. Proper servicing will al-
DE DE
low the best performance, a longer working life and
constant maintenance of safety requirements.
FR FR
Caution - warning
Before carrying out any servicing procedure,
ES
ES
activate all the safety devices provided and
decide whether staff at work and those in the
vicinity should be informed. In particular, turn
off the electricity supply using the circuit-
breaker and prevent access to all devices
English

LENGTHY DOWNTIMES OF APPLIANCE

USEFUL ADVICE FOR USE

SERVICING

RECOMMENDATIONS FOR SERVICING
3 - Spread a film of edible oil over the stainless
steel surfaces.
4 - Carry out all the servicing procedures.
5 - Cover the appliance, leaving a few gaps to al-
low air to circulate.
self.
– Always keep the appliance and the surrounding
areas clean.
– When cleaning, use only food-approved deter-
gents.
Caution - warning
Do not use the plates without pans; switch
them off when not in use.
which might people's health and safety at risk
if activated.
At the end of each session of use and whenever
necessary, clean:
– The plate (see page 9)
– The appliance and the surrounding environment
(see page 9)
Every 100 working hours have skilled, authorised
personnel carry out the following operations:
– Check that the electrical system is in good work-
ing order
- 8 -
5