Performance Chart - Flotec FPSES2700A Manual Del Usuario

Safety
READ AND FOLLOW
SAFETY INSTRUCTIONS!
This is the safety alert symbol. When you see this
symbol on your pump or in this manual, look for one of
the following signal words and be alert to the potential for
personal injury:
warns about hazards that will cause serious
personal injury, death or major property damage if ignored.
warns about hazards that can cause serious
personal injury, death or major property damage if ignored.
warns about hazards that will or can cause
minor personal injury or property damage if ignored.
The label NOTICE indicates special instructions which are
important but not related to hazards.
Carefully read and follow all safety instructions in this
manual and on pump.
Keep safety labels in good condition.
Replace missing or damaged safety labels.
NOTICE: Pump must be installed in a vertical position
only. Installing pump in any other position will void war-
ranty.
To avoid serious injury and/or property damage, read these
rules and instructions carefully.
Check your local codes before installing. You must comply
with local codes, the National Electrical Code (NEC) in the
United States or the Canadian Electrical Code (CEC), as
applicable.

PERFORMANCE CHART

Model
FPSES2700A
SPECIFICATIONS
Model HP Volts
FPSES2700A 3/4
NOTICE: For continuous duty, pump must be fully submerged in liquid with a maximum temperature of 130° F (54° C).
DIMENSIONS
Model Operation
FPSES2700A Automatic
For parts or assistance, call Flotec Customer Service at
GPH of Water at Total Feet of Head
5' 10'
6,960 5,580
Max Individual Branch
Load
Phase Amps
115 1 12.0
Pump Material
Base Housing Cover
304SS 304SS 304SS
Vent sewage or septic tank according to local codes.
In the United States, do not install pump in any location
classified as hazardous by National Electrical Code,
ANSI/NFPA 70-1984.
Pump normally runs hot. To avoid burns when servicing
pump, allow it to cool for 20 minutes after shut-down
before handling it.
Do not run pump dry. Dry running can overheat pump and
will void warranty.
Pump is permanently lubricated. No oiling or greasing is
required in normal operation. For overhaul, see instruc-
tions under "Service".
Hazardous voltage. Can shock, burn, or
cause death.
During operation the pump is in water. To avoid fatal
shocks, proceed as follows if pump needs servicing:
A. Ground pump according to all applicable codes and
ordinances.
B. Disconnect power to outlet box or circuit breaker
before servicing.
C. To reduce risk of electric shock, take care when chang-
ing fuses or resetting circuit breaker. Do not stand in
water when working on control box or with circuit
breaker.
D. When using cord and plug, plug into a grounded outlet
only. When wiring to a system control, connect pump
ground lead to system ground.
15'
4,440
Circuit Required Discharge
(Amps) NPT
15 2"
Dimensions
Impeller Height
304SS 16"
1-800-365-6832
20' 25'
3,360 2,220
Solids
Handling On
Capability Point
2" 21"
Cord
Diameter Length
9-1/2" 20'
2
Off
Point
13"
Wt.
24 Lb.