With each depression of key the bar becomes more and more visible by one
step.
For pain relief only increase the intensity, until you feel the application pleasant.
Under no circumstances the current may be painful.
For muscle relaxation, only increase the intensity until you fell slight twitches
under or around the electrodes. Underno circumstances the muscles may
painfully contract.
Stop the application if you feel it unpleasant or if pain occurs.
NOTE
After about 2 minutes from beginning of the therapy the
feeling of current can change. Increase the intensity step
by step until you sense again a pleasant feeling.
D
Ch1 Intensity = higher intensity, channel 1
With this key (D) you reduce the intensity at channel 1 by pressing the key once
or several times (the bar becomes lower, display
A current reduction always can be useful when the current selection changes
in the programs (also see "K operation mode setting/program selection") or
the application is felt unpleasant.
E
Frequency setting
This key is used to adjust the frequency of the therapy current, i.e. the number
of pulses that are emitted whilst current is being provided (see diagram 5).
2 Hz to 40 Hz are mainly used for muscle relaxation.
60 Hz to 200 Hz are used for pain relief.
CAUTION
Do not change suddenly from 200 Hz to 2 Hz, while you
have set the intensity, thus the treatment still runs. This
can cause painful twitches.
3 Operating
2
).
diagram 5
GB
29