Install Of Rad Series; Key Descriptions - Baxtran RAD Serie Manual De Usuario

User's Guide
Keep the scale dry. Precipitation, humidity and all types of liquids or moisture can contain minerals that will corrode electronic
circuits.
This scale is not waterproof designed (IP44), avoid high humidity that might cause condensation. Avoid direct contact with water. Do
not spray or immerse the scales in water. If scale meet water, reading data will be unstable, or scale will can't work correctly,
please turn off the power immediately, warm the scale, or call your dealer.
INSTALLATION OF RAD SERIES
The JWP Series comes with a stainless steel platform packed separately. Place the platform in the locating holes on the top cover. Do
not press with excessive force as this could damage the load cell inside.
Level the scale by adjusting the four feet. The scale should be adjusted such that the bubble in the spirit level is in the centre of the
level and the scale is supported by all four feet. If the scale rocks readjust the feet.
Attach the AC adapter output to the connector on the bottom of the scale. The power switch is located on the base near the front of the
scale. Power switch is at the right side of bottom cover, AC adapter jack also near the power switch, see attached drawing.

4. KEY DESCRIPTIONS

Set the zero point for all subsequent weighing. The display shows zero.
A secondary function
Tares the scale. Stores the current weight in memory as a tare value, substracts the tare valuefrom the weight and
shows the results. This is the net weight. Entering a value using the keypad will store that value as the tare value.
A secondary function ▲, of incrementing the active digit when setting a value for parameters or other functions.
Set the limits for check weighing. Allows setting for either the low limit or the high limit or both.
Secondary function ►, is to move the active digit to the right when setting values for paramteres or other functions.
Enters the percent weighing function. Allows the weight, unit weight, and count to be seen when parts counting.
Secondary function ◄, is to move the active digit to the left when setting values for parameters or other functions.
If the scale is weighing it will select parts counting. Of it is not in weighing mode it will return the user tp weighing.
Secondary function
To print the results to a PC using the optional RS232 interface or printer. It also adds the value (eright or quantity) to
the accumulation memory if the accumulation function is not automatic.
Secondary function ESC, is to return to normal operation when the scale is in a parameter setting mode.
In the counting mode, press the key to display the unit weight/count/total weight. In the weighing mode, press the key
to shift the unit. In the percent weighing mode, press this key to display the weight temporary then after 3 seconds
back to the percent weighing mode.
22
, of "Enter" key when setting parameters or other functions.
, is to act as a clear key when setting values for parameters or other functions.
Top loading scale Model RAD