Automatic Accumulation; Battery Operation - Baxtran RAD Serie Manual De Usuario

Model RAD
To view the totals in memory press the
and the total weight before returning to zero. The totals will also be printed via the RS232 interface.
To erase the memory press
NOTE: M+/Print function only available when stable (

AUTOMATIC ACCUMULATION

When the scale has been set to Automatic accumulation the value is stored in memory automatically.
Add a weight to the scale, the beeper will sound when the scale is stable to signify the value is accepted. Remove the weight.
The display will show "ACC1" and the totals in memory when the scale returns to zero. Adding a second weight will repeat the pro-
cess.
While the weight is on the scale it is permissible to press the
store the value when the weight is removed.
The totals can be viewed as above.
In all cases the scale must return to zero or a negative number before another sample can be added to the memory. More product can
then be added and pressed again. This can continue for up to 99 entries, or until the capacity weight display is exceeded.

7. BATTERY OPERATION

The scales can be operated from the battery if desired. The battery life is approximately 70 hours.
When the battery needs charging the arrow above the low battery symbol under the weight display will turn on. The battery should be
charged as soon as the arrow above the symbol is on. The scale will still operate for about 30 minutes after which it will automatically
switch off to protect the battery. (during low battery term, display will show "BAT LO" every 5 minutes.)
To charge the battery simply plug into the AC adapter. The scale does not need to be turned on.
The battery should be charged for 12 hours for full capacity.
Just above the display is an LED to indicate the status of battery charging. When the scale is plugged into the mains power the internal
battery will be charged. If the LED is green the battery has a full charge. If it is Red the battery is nearly discharged and yellow
indicates the battery is being charged.
As the battery is used it may fail to hold a full charge. If the battery life becomes unacceptable then contact your distributor.
NOTE: New batteries are shipped partially charged. Before you can use your scale, you need to install and charge the battery, as
indicated by the following instructions. Some batteries perform best after several full charge/discharge cycles. Battery performance
depends on many factors, including your backlight setting and operate.
To maximize your battery's performance:
▪ Always use Original batteries and AC adapter. The scale warranty does not cover damage caused from using non original batteries
and/or battery chargers.
▪ The rating of AC adapter output is 9V, but normal output range will be 11V~15V
▪ New batteries or batteries that have been stored for long periods of time may require a longer charge time.
Top loading scale
key when the scale is at zero. The display will show the total number of items "ACC xx"
to view the totals and then press the
○
indicator on).
Never use any charger or battery which is damaged.
Do not short-circuit the battery. Accidental short-circuiting can occur when a metallic object (coin,
clip or pen) causes direct connection of the + and - terminals of the battery (metal strips on the
battery) for example when you carry a spare battery in your pocket. Short-circuiting the terminals
may damage the battery or the connecting object.
Do not dispose of batteries in a fire.
Dispose of batteries according to local regulations (e.g. recycling). Do not dispose as household
waste.
Avoid charging under airless conditions
key to clear the memory.
key to store the value immediately. In this case the scale will not
User's Guide
25