Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
User's Guide
PARTS COUNTING
When the scale is showing weight, pressing the
Before beginning, tare the weight of any container that will be used, leaving the empty container on the scale. Place the number of
samples on the scale. The number should match the options for parts counting: 10, 20, 50, 100 or 200 pieces.
Press the
key to begin. The scale will show "SP10" asking for a sample size of 10 parts. Change the sample size by pressing the
key. The display will cycle through the options: 10, 20, 50, 100, 200 and back to 10.
Press the
key when the number matches the number of parts used for the sample. As more weight is added the display will show
the number of parts (pcs).
Press the
key to display unit weight (g/pcs), Total weight (kg) or the count (pcs). Press the
hing.
CHECK-WEIGHING
Check-weighing is a procedure to cause an alarm to sound when the weight on the scale meets or exceeds values stored in memory.
The memory holds values for a high limit and low limit. Either can be used or both can be used.
Press the
key. The display will show the current High Limit with the left most digit flashing and the HI symbol on to the left of the
display.
To change the value shown use the
When the desired value is shown press the
clear the value.
After pressing the
Enter the low limit in the same way the high limit was entered.
After pressing the
When a weight is placed on the scale the arrows will show if the weight is above or below the limits and the beeper will sound as your
setting (see detail in section 9).
BOTH LIMITS SET
The display will show OK when the weight is between the limits.
LOW LIMIT SET, HIGH LIMIT is set to zero
The display will show OK when the weight is less than the Low Limit. Above the Low Limit the display will show HIGH.
HIGH LIMIT SET, LOW LIMIT is set to zero
The display will show LOW when the weight is less than the High Limit. Above the High Limit the display will show OK.
BOTH LIMITS SET, LOW IS SET GREATER THAN HIGH
The beeper will never sound and the display will show LOW if the weight is less that the LOW limit, and HIGH if the weight is
greater than the Low Limit.
NOTE: The weight must be greater than 20 scale divisions for the checkweighing to operate.
To disable the Check-Weighing function enter zero into both limits by pressing the
pressing the
ACCUMULATED TOTAL
The scale can be set to accumulate automaically when a weight is added to the scale or manually by pressing the
PARAMETERS section for details of selecting the method. The accumulation function is only available when weighing . Is is disabled
during percent weighing or parts counting.
MANUAL ACCUMULATION
When the scale is set to manual accumulation the weight displayed will be stored in memory when the
weight is stable.
The display will show "ACC1" and then the total in memory for 2 seconds before returning to normal. If the optional RS232 interface is
installed the weight will be output to a printer or PC.
Remove the weight, allowing the scale to return to zero and put a second weight on. Press
show the new total. Continue until all weights have been added.
24
and
key the display will then show the Low Limit, the LO symbol will be on the left side of the display.
key the scale will return to weighing with the Check-weighing function enabled.
key to store the zero values.
Top loading scale
key will start the parts counting function.
to select the digit to change. Then use the
key to accept the value. If you want to reset the value to zero press the
Model RAD
key to return to normal weig-
key to increment the flashing digit.
key when the current limits are shown then
key is pressed and the
, the display will show "ACC2" and then
key to
key. See the
Publicidad
Tabla de contenido
