Console (Fig. E-1); Buttons; Explanation Of Display Items - Tunturi cardio fit t30 Manual Del Usuario

If the equipment shuts down, proceed as follows to
restart the equipment:
- Remove the mains plug from the equipment.
- Press the circuit breaker to restart the equipment.
- Insert the mains plug into the equipment.
‼ NOTE
• Some circuit breakers used in homes are not
rated for high inrush currents that can occur
when a treadmill is first turned on or even
during normal use. If your treadmill is tripping
the circuit breaker (even though it is the
proper current rating and the treadmill is the
only appliance on the circuit) but the circuit
breaker on the treadmill itself does not trip,
you will need to replace the breaker with a
high inrush type. This is not a warranty defect.
This is a condition we as a manufacture have
no ability to control.
Unfolding and folding the
equipment (fig. F1-F2)
The equipment can be unfolded for use (fig. F1) and
folded for transport and storage (fig. F2).
Refer to the illustrations for the correct way of
unfolding and folding the equipment.
Adjust incline setting (Manual)
- Fold up your treadmill. (Up)
- Take out adjuster pad safety pin.
- Adjust the adjuster pad in desired position.
- Secure the adjuster pad position with the safety
pin.
- Unfold your treadmill. (Down)
‼ NOTE
• Make sure both adjuster-pads are in same
position to avoid your treadmill to become
unstable.

Console (fig. E-1)

⚠ CAUTION
• Keep the console away from direct sunlight.
• Dry the surface of the console when it is
covered with drops of sweat.
• Do not lean on the console.
‼ NOTE
• The console switches to standby mode when
the equipment is not used for 10 minutes.

Buttons

Stop
- Stop workout.
Speed +
- Increases the speed (0.8 ~ 12 KM/H).
- Pressing once increases the speed 0,1 kph.
- Pressing and holding for two seconds will increase
the speed faster.
- Scroll programs and change values in
programming mode.
Speed -
- Decreases the speed (0.8 ~ 12 KM/H).
- Pressing once decreases the speed 0,1 kph.
- Pressing and holding for two seconds will
decrease the speed faster.
- Scroll programs and change values in
programming mode.
Mode
- Select program mode
- Confirm setting to enter next step in
programming mode.
Prog
- Select program mode. ( P1 ~ P12, FAT)
Start
- Start selected workout
Speed hot keys:
Speed Hot Keys are set as: 2, 3, 4, 5, 6, 7, 8, 9, 10,
11.
For example, the speed changes from any speed to
8 KPH by pressing the
Speed Hot Key 8.

Explanation of display items

Speed
- Shows the actual treadmill speed in workout
mode.
- Shows target speed in programming mode.
Distance
- Shows the ran distance workout mode.
- Shows the target distance when being in
programming mode.
- Shows program selection when being in program
mode.
English
17