Water Treatment - Teuco Hydrospa 620 Manual Del Usuario

EN
8.
Set the pump switch to "MAN" (manual).
Water will begin flowing from the pool through the
filter.
9. BLEEDING THE FILTER
Turn the bleed valve located on the the filter cap.
Take care over this step, as an accumulation
of air in the filter can cause the system to
malfunction seriously and shorten the life of the
pump.
Repeat the operation several times if necessary.
After bleeding the filter, set the pump switch to the
"AUTO" position .

WATER TREATMENT

Treat the water using the products supplied by Teuco, as described in the accompanying manual.
Other equivalent proprietary products can also be used.
The pH value and Chlorine level must be tested chemically at frequent intervals to guarantee the quality
of the water is properly maintained and ensure correct operation of the system.
620
37