Connecting The Pressure Washer To The Water Supply - Stihl RE 90 Manual De Instrucciones

Ocultar thumbs Ver también para RE 90:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English
2
1
► Unscrew connector (1) from water tap (2).
► Screw water filter (3) onto water tap (2) and tighten hand-
tight.
► Screw connector (1) onto water filter (3) and tighten hand-
tight.
► Push hose coupling (4) of water hose (5) onto
connector (1).
8.2
Connecting the pressure washer to the water
supply
Connecting the water hose
The water hose must meet the following requirements:
– The water hose has a diameter of 1/2".
– The water hose is between 10 m and 25 m long.
► Connect water hose to a water tap.
► Turn on the water tap fully and rinse the water hose with
water.
Sand and dirt will be rinsed out of the water hose. The
water hose will be vented.
► Turn off water tap.
54
2
3
1
4
4
► Insert water intake screen (1) into the connector (2).
5
► Screw connector (3) onto connector (2) and tighten hand-
tight.
► Push the coupling (4) onto the connector (2).
The coupling (4) audibly engages.
► Open water tap fully.
► If the spray lance is fitted to the spray gun: Remove spray
lance.
► Keep the trigger of the spray gun pressed until an even jet
of water is delivered by the spray gun.
► Release spray gun trigger.
► Lock spray gun trigger.
► Fit spray lance.
► Attach the nozzle.
Remove water hose
8 Connecting to a water source
2
1
3
2
1
0458-814-8721-A

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido