Loctite 883976 Manual De Operación página 8

pre-determined amount of product to be
incrementally added in steps if desired.
5.2.1 Setting the Timer in the Timed Mode
5.2.1.1 From the Timed Mode , press and hold button the
Set button (3) for 2 seconds. The unit will enter
the Set- up Mode and allow each or the time
digits to be set.
5.2.1.2 Pressing the Set button (3) from this point moves
the the cursor to the next digit and back till the
desired time has been set
5.2.1.3 Press the (+) and (-) button to set the time for
each digit desired. (You can not go past 0 with
either button.) Minimum dispense time is 00.020
seconds
5.2.1.4 When your desired time has been entered, press
and hold the Set button (3) for two seconds to
save the data.
5.2.2 Setting the Timer in the Incremental Mode
Setting the timer from the Incremental mode, "Teach
Mode" is helpful in determining dispense time
required when dispense output is unknown. The timer
will continue to accumulate time as long as the foot
pedal is depressed, allowing the user to "teach" the
unit the exact time needed
5.2.2.1 From the Incremental Mode, press and hold the
Set button (3) to enter the "Teach Mode". The
unit will still read Set-up, however the time will
show "0.000" in the LCD.
5.2.2.2 Press and hold down the foot switch. Product
will dispense and time will accumulate. Continue
to release and press the foot switch till the desired
quantity has been dispensed.
5.2.2.3 Press and hold the Set button (3) for two seconds
to save the data.
8