Publicidad
Idiomas disponibles
Idiomas disponibles
GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1
MRA screen
1
Edge protection trim
Fitting the screen to the motorcycle:
1. Stand your motorbike up on a level surface.
2. Remove the mirrors from each side (P1).
3. Remove the original screws fastening the screen, and carefully remove the original
screen.
4. Remove the rubber nuts from the original screen and place them into your MRA
screen (P2). Leave the rubber grommets in the original screen (P3).
5. Carefully place your MRA screen into the fairing.
6. Take the original fastening screws, insert them into the holes and carefully tighten
them up.
7. Mount the mirrors back on again.
8. Mount the edge protection strip onto the screen as shown in Figure 4.
9. Slide the end sleeves over the end of the edge protector strip and gently squeeze the
sleeves with a pair of pliers to secure the edge protector strip.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
BMW S1000RR 2015-
Article No..
---
Wrench 10mm
---
Torx T20
3
Required tools
Publicidad
