Installing The Unit; General Requirements For Installation; Fastening The Unit - Ingeteam INGEREV RAPID 50 Trio Manual De Instalacion Y Uso

Installing the unit

6. Installing the unit
Before installing the unit, the packaging must be removed, taking special care not to damage the housing (see
section "4.2. Unpacking").
Check that there is no condensation inside the packaging. If there are signs of condensation, the unit must not be
installed until you are sure it is completely dry.
CAUTION
All installation operations must comply with current regulations.
All operations involving moving heavy weights must be carried out using the required mechanical means (crane,
hoist, etc.).

6.1. General requirements for installation

• The environment of the unit must be appropriate and meet the guidelines described in chapter "5.
Preparation for installing the unit". Additionally, the parts used in the rest of the installation must be
compatible with the unit and comply with the applicable legislation.
• The ventilation and workspace must be suitable for maintenance tasks according to the applicable
regulations in force.
• The external connection devices, which must be suitable and sufficiently close as set forth in current
regulations.
• The feed cables must be of the appropriate gage for the maximum current.
• Special care must be taken to ensure that there are no external elements near the air inlets and outlets
that obstruct proper cooling of the unit, respecting the distances indicated in section "5.1. Environment".

6.2. Fastening the unit

To fasten the unit, bolt a series of bolts to the ground via the dedicated holes on the sides of the lower base.
Follow these steps:
1. Mark the fixing points on the floor.
2. Drill the ground with a proper bit.
3. Bolt through the base's holes.
4. Check that the unit properly secured.
Once the unit has been installed correctly, the connection process will begin.
ABT2012IQM01_ - Installation and Operation Manual
Ingeteam
EN
ES
FR
IT
27