Local Connection Via Wi-Fi; Remote Connection - Ingeteam INGEREV RAPID 50 Trio Manual De Instalacion Y Uso

Ingeteam

10.1.2. Local connection via Wi-Fi

By default the unit is configured in Access Point mode. This means that it creates as Wi-Fi network that allows
connections from devices such as laptop computers, tablets or smartphones.
To make the connection, follow these steps:
1. Connect the device to the network created by the charger. The network name will be the same as the
unit's serial number.
2. On the device, open the browser and open http://192.168.2.1:8080.
3. Enter the username and password. The username and password are specified on the green card delivered
with the unit.
4. Follow the instructions given by INGEREV WEB Manager.

10.2. Remote connection

The purpose of remote connection is to have access to the charger when the charger and the computer are
connected to the Internet from different communication networks. The charger must be connected to the Internet
via Wi-Fi, Ethernet or 3G.
To make the connection, follow these steps:
1. With the charger and the computer connected to the Internet, open the web browser and open http://www.
ingerev.com/SerialNum, where SerialNum corresponds to the unit's serial number (for example, http://
www.ingerev.com/6H0576543210). The serial number is the unit's unique identification and is located
on the specifications plate.
2. Enter the username and password. The username and password are specified on the green card delivered
with the unit.
34 ABT2012IQM01_- Installation and Operation Manual
Configuration