MRA 4025066148646 Instrucciones De Montaje página 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA screen
3 Round head screws M5 x 20
3 Plastic washers Ø 12x5
3 Neoprene washers 16 x 4,5 x 4mm
1 Edge protection strip, sleeves
Fitting the screen to the motorcycle:
1. Stand your motorbike up on a level surface.
2. Unscrew and remove the original screen (P1).
3. Insert the screws with the plastic washers into your MRA screen, and slide the
enclosed rubber spacers onto the screws from the inside.
4. Adjust the screen's position on your bike and turn the screws into the mounting holes,
and then tighten the screws.
5. Apply the edge guard profile to the exposed rear area of the windshield, starting at
the fairing transition and ending at the opposite side. Cut off the rest if required.
6. It is also possible to push the clamping sleeves over the ends of the protective edge
strip and lightly compress these using a pair of pliers to secure the edge strip.
7. Fit the edge protector strip onto the screen. Place the end sleeves over the end of the
edge protector strip and gently squeeze the sleeves with a pair of pliers to secure the
edge protector strip.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
BMW S1000R 2014-
Article No..
--- Torx 25
10673 Allen key 3mm
10635
10634
---
3
Required tools