MRA 4025066164950 Instrucciones De Montaje página 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA windscreen
1 Pair of retaining plates
4 M5 rubber nuts
4 Lens head screw, black, M5x16mm
8 Plastic disc 12x5x0.5mm
2 Distance sleeves 3mm
2 Distance sleeves 6mm
2 Lens head screws, M5x20mm
2 Lens head screws, M5x25mm
4 O-rings, 4.5x1.5mm
Fitting the screen to the motorcycle:
1. Place the motorcycle on a flat surface.
2. Remove the original windscreen.
3. Mount the provided retaining plates [11366] with the M5x16mm lens head screws [10554]
and the plastic washers [10635] at the motorcycle. Insert the provided rubber nuts [10629]
into the retaining plates (P1).
4. Insert the provided M5x20mm lens head screws [10673] with the plastic washers [10635]
into the upper holes at the MRA windscreen. Afterwards, apply the 3mm distance pieces
[10872] from the back and secure them with the O-rings [10992].
5. Insert the provided M5x25mm lens head screws [10641] with the plastic washers [10635]
into the lower holes at the MRA windscreen. Afterwards, apply the 6mm distance sleeves
[11038] from the back and also secure them with the O-rings [10992].
6. Finally, mount the MRA windscreen to the motorcycle and tighten the screws.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
Triumph Tiger 800/XRX/XRT
Article No..
--- Allen key 3mm, 5mm
11366
10629
10554
10635
10872
11038
10673
10641
10992
2
Required tools