Tabla de contenido
Publicidad
SECTION
3: ADJUSTMENTS
ADJUSTING THE OPERATORS SEAT
•
To adjust the positionof the seat, move and hold
the seat adjustment lever toward the left. Slide
the seat forward or rearward to the desired
position;then release the adjustment lever. Make
sure seat is locked into position before operating
the tractor. See Figure20,
Seat
Figure 20
ADJUSTING
RH & LH DRIVE CONTROL
LEVERS
The RH and LH drive control levers can be adjusted
up or down and fore-and-aft
for the comfort of the
operator.
The drive control levers
can be placed
in
either of two height positions,
and/or can be moved
forward
or rearward
within
the range of the slot in
each control lever mounting bracket.
To adjust the drive control
lever height,
proceed as
follows:
Remove the flange lock nut, flat washer, and hex
screw securing the lever to the pivot bracket.
While supporting
the control lever to keep it from
falling, remove the hex insert flange lock nut and
shoulder
screw from the bottom
of the control
lever and pivot bracket. Refer to Figure 21.
°
Reposition
the control lever to align with the other
set of holes in the pivot bracket
and insert the
shoulder screw removed earlier.
Fasten with the
hex insert flange lock nut and tighten until snug.
o
Insert
the
hex
screw
w/washer
through
the
control lever slot and the pivot bracket.Thread
the
flange lock nut onto the screw, but do not tighten
now.
If you are going to adjust the control levers
forward or rearward, proceed to the next step. If
not, fully the flange lock nut.
Pivot Bracket
Screw
Figure 21
To adjust the drive control levers forward or rearward,
proceed as follows:
If not already
loose, loosen the flange lock nut and
rotate the control lever either forward or rearward
to
the desired position. See Figure 21.
NOTE: If the control lever is too tight to move, slightly
loosen the hex insert flange lock nut and shoulder
screw at the bottom of the control lever.
Tighten the flange lock nut to fix the control lever
in the adjusted position
Repeat the above procedure
to adjust the other
control
lever into the same
position.
Adjust
so
that both levers are even with each other when in
the neutrat position.
20
Publicidad
Tabla de contenido
