BDS Maschinen MAB 1300 Instrucciones De Manejo página 19

W e l d o n i n d u s t r i a l t o o l h o l d e r
M A B 1 3 0 0
NOTE
► When using tools with Weldon shank, the tool holder with
retainer must be assembled (delivery condition) .
For further information, see the section Dismantling/
assembling the tool holder .
In s e r t i n g t h e t o o l
Before inserting, clean the Weldon shank of the tool and the
‹
tool holder .
Loosen both Allen screws in the tool holder with the Allen key
‹
(H) supplied .
Insert the tool into the tool holder .
‹
NOTE
► Use the ZAP 200 (A) reducing ring for tools with
Weldon shank .
► Insert the appropriate ejector pin (B,C,D,E) before inserting
a core drill .
Tighten both Allen screws in the tool holder using the Allen
‹
key (H) supplied .
R e m o v i n g t h e t o o l
Loosen both Allen screws in the tool holder using the
‹
Allen key (H) supplied and remove the tool by pulling it
downwards .
Remove the ZAP 200 reducing ring (A), if necessary .
‹
P r e p a r a t i o n
19mm)
3 / " (
4
1 9