Setting The Speed; Setting The Torque Cut-Off - BDS Maschinen MAB 1300 Instrucciones De Manejo

Se t t i n g t h e s p e e d
Se t t i n g t h e t o r q u e c u t - o f f
M A B 1 3 0 0
In addition to the mechanical gearbox, the machine is also
equipped with full-wave control electronics for stepless variable
speed adjustment .
First set the appropriate gear stage, then adapt the speed
‹
using the electronic speed control (31) .
Ge a r s t a g e
Stage 1
Stage 2
Stage 3
Stage 4
NOTE
► If possible, always select a setting with low gear stage and
high motor speed . The motor is then set with a higher torque
and therefore protected against overheating under heavy
load .
In order to protect the tool, the maximum torque of the machine
can be set using the controller (32) .
The machine switches off when it reaches the maximum set
torque . After switching off, the machine must be switched off and
on again using the ON/OFF switch (21) .
CAUTION
► Do not use this function to switch off the machine when
cutting threads in pocket holes .
Sp e e d r a n g e
30 - 80 min -1
50 - 120 min -1
130 - 350 min -1
210 - 550 min -1
O p e r a t i o n
2 5