Drilling With The Machine - BDS Maschinen MAB 485 Instrucciones De Manejo

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

D r i l l i n g w i t h t h e m a c h i n e
D r i l l i n g w i t h t w i s t d r i l l s
CS Unitec, Inc. • Phone: 203-853-9522 • Toll-free: 800-700-5919 • Email: info@csunitec.com
M A B 4 8 5
Proceed as follows when drilling with twist drills:
Push twist drills with MK taper from below into the morse
taper (3) of the machine .
Push twist drills with straight shank into the drill chuck after
fitting the drill chuck (H).
Position the machine at the working location, align it and
switch on the magnetic clamps .
Select the appropriate speed and switch on the machine .
NOTE
Observe the following instructions when drilling with twist drills:
Under high pressure, the drill can glow out and the machine
can be overloaded .
When working overhead, use the high-performance grease
spray ZHS 400 . Spray the drill with grease spray before
drilling . Repeat the procedure when drilling deep holes .
Pay attention to a regular chip discharge . With larger drilling
depths, the chip may break .
www.csunitec.com
O p e r a t i o n
2 3

Publicidad

Tabla de contenido
loading

Tabla de contenido