BDS Maschinen MAB 485 Instrucciones De Manejo página 18

P r e p a r a t i o n s
Sa f e t y p r e c a u t i o n s
M K t o o l m o u n t i n g
CS Unitec, Inc. • Phone: 203-853-9522 • Toll-free: 800-700-5919 • Email: info@csunitec.com
1 8
W A R NING
R i s k o f i n j u r y !
► Do not use damaged, soiled or worn tools .
► Carry out tool changes only when the machine is switched
off and at a standstill . Remove plug from the mains socket .
► After inserting, check that the tool is engaged securely .
► Only use tools, adapter and accessories that match the
machine .
In s e r t i n g t h e t o o l
Before mounting, clean the shank of the tool, adapter or drill
‹
chuck and the morse taper (3) of the machine .
Push the tool from below into the morse taper (3) of the
‹
machine .
W A R NING
R i s k o f i n j u r y f r o m
► Check the proper seating of the tool, adapter or drill chuck in
the MK tool mounting .
R e m o v i n g t h e t o o l
Turn the tool until the ejector pin (E) slips into the opening for
‹
the ejector pin (4) .
Prise out the tool with the ejector pin (4) or loosen the tool by
‹
tapping against the ejector pin .
www.csunitec.com
i n c o r r e c t l y i n s e r t e d t o o l !
M A B 4 8 5