BDS Maschinen MAB 485 Instrucciones De Manejo página 24

O p e r a t i o n
D r i l l i n g w i t h c o r e d r i l l s
CS Unitec, Inc. • Phone: 203-853-9522 • Toll-free: 800-700-5919 • Email: info@csunitec.com
2 4
Proceed as follows when drilling with core drills:
Install the quick-change drill chuck system (A) and connect
‹
up the cooling lubricant system .
Install the appropriate ejector pin in the core drill and insert
‹
the core drill into the quick-change drill chuck system (A) .
Position the machine at the working location, align it and
‹
switch on the magnetic clamps .
Select the appropriate speed and switch on the machine .
‹
NOTE
Observe the following instructions when drilling with core drills:
► Drilling with core drills requires no great effort . The drilling
process is not accelerated by higher pressure . The drill
wears faster and the machine can be overloaded .
► Use the cooling lubricant system installed on the machine
with high-performance cutting oil from CS Unitec .
► The cooling lubricant system cannot be used when working
overhead . In this case use the high-performance grease
spray ZHS 400 . Spray the drill on the inside and outside
before drilling . Repeat this procedure when drilling deeper
holes .
► Pay attention to a regular chip discharge . With larger drilling
depths, the chip may break .
www.csunitec.com
M A B 4 8 5