Manhattan - Bronpi LORCA-C Insrucciones De Instalacion Y Del Operador

- Lately place the top coating (5) in the cornice coating (4) with the screws (c) (see drawing D19)
- Finally place the cover coating (6) in the top coating (5) with the screws (d) (see drawing D20)
- In order to end the installation you must place the trim (7) and the telescopic (8) (see drawing D21)
2.1.4.

MANHATTAN

To install the Manhattan model, please follow the next steps:
First of all, we will identify the components of the fireplace (see drawing D22)
- Start the installation screwing the anchoring supports (1) to the wall with high resistance blocks for 8 mm. The minimum height of the
lower part from the anchoring to the floor must be 600 mm (see drawing D23)
D22
D25
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
D19
DISTANCIA
HORIZONTAL ENTRE
ANCLAJES 520 mm
1: Anchoring support
2: Combustion body
3: Side coating
4: Cornice coating
5: Top coating
6: Cover coating
7: Trim
8: Telescopic
D24
- Then put the combustion body (2) to the anchoring supports
D26
(1) with the three lateral screws (a). (See drawing D24)
- In third place put the side coating (3) in the body (2) and fix
this sides with the rear screws (see drawing D25)
- Put the cornice coating (4) in the ceiling of the body (2) with
the screws (b) (see drawing D26)
- Then place the top coating (6) in the cornice coating (4) with
the screws (c). In this moment you must also place the smoke
exit duct on the top coating (6) and place the telescopic (7) (see
drawing D27)
- Finally place the cover coating (5) in the top coating (6) with
the screws (d) (see drawing D28)
- To end the installation you must screws to the ceiling the
telescopic (7) (see drawing D29)
18
D20
METALLIC FIREPLACES
D21
D23