Clarion DXZ788RUSB Manual De Instrucciones página 15

01_DXZ788RUSB_EN.book 15 ページ ２００７年１１月２７日 火曜日 午後６時３４分
Basic Operations
Adjusting Sound Mode
To change sound mode
1. Press the [ ] button and select the sound
mode to adjust.
2. Push the [SEEK PANEL] leftward or
rightward to select the "item name".
When speaker system is "NORMAL":
"S-W VOLUME" "DZE"
"BASS" "TREBLE"
"HPF" "S-W LPF"
"FADER"
When speaker system is "3WAY":
"S-W VOLUME" "DZE"
"BASS" "TREBLE"
"BALANCE"
When speaker system is "2WAY":
"DZE" "P.EQ" "BASS"
"S RESTORER" "BALANCE"
"FADER"
3. Push the [P.CH] button upward or
downward to select the "desired setting
value".
∗ In the case of item names appearing with
the "ENT" suffix after the item name, the
[ ] button must be pressed to display
the setting value.
∗ "P.EQ" can be adjusted only when the
"P.EQ ON/OFF" is set to "ON" (page 22)
and "EQ SELECT" is set to "P.EQ" (page
22).
∗ "BASS" and "TREBLE" can be adjusted
only when "DZE" is set to "DZE OFF" (page
15) and "EQ SELECT" is set to "B/T" (page
22).
∗ After completing settings, press the
button to return to the previous mode.
Note:
• During sound adjustment mode, if no
operation is performed for more than 10
seconds, this mode can be canceled and
return to the previous mode.
Adjusting the subwoofer output
volume
You can adjust the volume output from the unit's
subwoofer output terminal.
"S-W VOLUME" can be adjusted only when
"SUB WOOFER" is set to "ST" or "MONO"
(page 22).
2-1. Select the "S-W VOLUME".
3-1. Push the [P.CH] button upward or
Setting the Digital Z-Enhancer
This unit are provided with 3 types of sound tone
"P.EQ"
effects stored in memory. Select the one you
"S RESTORER"
prefer.
"BALANCE"
∗ The factory default setting is "DZE OFF".
2-1. Select the "DZE".
3-1. Press the [
"P.EQ"
"S RESTORER" 3-2. Push the [SEEK PANEL] leftward or
"TREBLE"
3-3. When the "DZE 1", "DZE 2" or "DZE 3" is
[ ]
downward to change the output volume.
∗ The factory default setting is "0".
(Setting range: +6 to –6)
] button.
rightward to select the tone effect. Each
time you push the [SEEK PANEL], the tone
effect changes in the following order:
"DZE OFF" "DZE 1" "DZE 2"
3"
DZE OFF : No sound effect
DZE 1 : Suitable for genuine speakers
DZE 2 : Suitable for separate
speakers
DZE 3 : Suitable for co-axial speakers
set, push the [P.CH] button upward or
downward to change the DZE level from +3
to –3.
∗ The factory default setting is "0".
DXZ788RUSB
"DZE
15