Clarion DXZ788RUSB Manual De Instrucciones página 18

01_DXZ788RUSB_EN.book 18 ページ ２００７年１１月２７日 火曜日 午後６時３４分
Basic Operations
Adjusting the bass
2-1. Select "BASS".
3-1. Press the [ ] button.
3-2. Push the [P.CH] button upward or
downward to adjust the gain from –6 to +6
(The factory default setting is "0").
3-3. Press the [ ] button to return to the
previous mode.
Adjusting the treble
2-1. Select "TREBLE".
3-1. Press the [ ] button.
3-2. Push the [P.CH] button upward or
downward to adjust the gain from –6 to +6
(The factory default setting is "0").
3-3. Press the [ ] button to return to the
previous mode.
Adjusting the sound restorer
The sound restorer enriches the playback of all
types of music files that have undergone any
level of data compression.
2-1. Select "S RESTORER".
3-1. Push the [P.CH] button upward or
downward to adjust.
Each time you push the [P.CH] button, the
sound restorer changes in the following
order:
"OFF" "1" "2" "3"
∗ The factory default setting is "OFF".
Set this adjustment in accordance with the
music source used.
OFF: For music sources compressed at
high bit rate
1: For music sources compressed for high
quality at low bit rate
2: For music sources compressed for
standard quality at low bit rate
3: For music sources compressed for low
quality at low bit rate
18
DXZ788RUSB
Adjusting the balance
2-1. Select "BALANCE".
3-1. Push the [P.CH] button upward to
emphasize the sound from the right
speaker, push the button downward to
emphasize the sound from the left speaker.
∗ The factory default setting is "0".
(Adjustment range: L12 to R12)
Adjusting the fader
"FADER" can be adjusted only when the
speaker system is set to "2WAY" or "NORMAL".
2-1. Select "FADER".
3-1. Push the [P.CH] button upward to
emphasize the sound from the front
speaker, push the button downward to
emphasize the sound from the rear
speaker.
∗ The factory default setting is "0".
(Adjustment range: R12 to F12)
Setting high pass filter
"HPF" can be adjusted only when the speaker
system is set to "NORMAL".
∗ The factory default setting is "THRGH" (through).
2-1. Select "HPF".
3-1. Push the [P.CH] button upward or
downward to select the setting. Each time
you push the [P.CH] button, the setting
changes in the following order:
"THRGH" "50Hz" "80Hz"
Setting low pass filter
"S-W LPF" can be adjusted only when the
speaker system is set to "NORMAL".
∗ The factory default setting is "THRGH" (through).
∗ If subwoofer function is set to "ST" or "MONO",
"S-W LPF" can be selected.
2-1. Select "S-W LPF".
3-1. Push the [P.CH] button upward or
downward to select the setting.
Each time you push the [P.CH] button, the
setting changes in the following order:
"THRGH" "50Hz" "80Hz"
"125Hz"
"125Hz"