Power Connection; Switch On And Off; Setting Cutting Height - STERWINS 320 EP-2 Manual De Instrucciones

POWER CONNECTION

CAUTION!
Do not switch on the unit until it has been completely assembled. Before
switching on the unit, always check the connection cable for signs of
damage; only on undamaged connection cable may be used.
Note: Damaged connection cables are highly dangerous!
The mains voltage (230-240V~) indicated on the rating plate must correspond with
the mains power supply. Mains connection fuse: min.10A.
1. Insert the mains plug of the unit connection cable into the combined switch/
plug. (As fig 5 show)
2. Secure with the cable grip. The loop of the mains cable must be adequately
long so that the cable grip can slide from one side to the other.
SWITCHING ON AND OFF (fig 9)
Do not start the motor in tall grass.
Switch on: press the button on the combined switch/plug. Hold down the on
button and pull the switch bar
1
-the safety lever does into lock into position.
Switch off: release the switch bar.
Note: While mowing, lay the connection cable safely on footpaths and on areas
which have already been mown.
WARNING!
When the motor has been switched off, the cutter continues running
for several seconds therefore do not touch the underside of the
mower until the cutter has come to a standstill!
SETTING CUTTING HEIGHT (fig 7.)
Note:
Comply with the national/municipal regulations concerning the times
when the mower may be used (if required, contact your local authority).
If you want to change the cutting height, please put the machine upside down.
Warning!
Before you turn the machine upside down be sure that the machine is stopped
and not power connected onto the switch. If not danger might be occurred.
You can pull the real axle near the wheel out of the gear position, against the spring
force, and set in the position you want. There are 3 positions there. You should
repeat these on both rear wheels and both front wheels.
Note:Be sure that the rear/ front wheels are in same position.
towards the handle and hold in position
2
EN - 17