Publicidad
Idiomas disponibles
Idiomas disponibles
VisionAire™
The concentrator should be located as to avoid pollutants or
fumes.
If oxygen does not seem to flow, first verify that the flowmeter
ball is registering a flow. Then, place the tip of the cannula into
a glass of water; if bubbles come out of the cannula, oxygen is
flowing. If bubbles do not appear, refer to Section 5.0.
Troubleshooting.
To prevent a voided AirSep warranty, follow all manufacturers'
instructions.
Replace the disposable cannula periodically following normal
usage according to your Equipment Providers
recommendations.
AirSep does not recommend the sterilization of this
equipment.
Do not attempt any maintenance other than the possible
solutions listed below.
If the unit has not been used for an extended time period, it
needs to operate for several minutes before power failure
alarm can become activated.
Portable and mobile RF communications equipment can affect
medical electrical equipment.
®
AirSep
Corporation
MN137-1 rev. D
EN
EN
EN-5
EN-6
The concentrator releases warm air out the bottom of the unit
which can permanently discolor temperature sensitive flooring
surfaces such as vinyl. The concentrator should not be used
over flooring that is sensitive to heat staining. AirSep is not
responsible for flooring that becomes discolored.
"No Smoking – Oxygen in Use" signs must be prominently
displayed in the home or where the oxygen concentrator is in
use. Patients and their caregivers must be informed about the
dangers of smoking in the presence of, or while using, medical
oxygen.
VisionAire™
®
AirSep
Corporation
MN137-1 rev. D
Publicidad
