Transporting The Saw - Evolution S355 CPSL Instrucciones Originales

www.evolutionpowertools.com
ASSEMBLY & PREPARATION
(5.5)
PERMANENTLY MOUNTING
A CHOP SAW
WARNING: Only attempt the following
procedures with the machine disconnected
from the mains power supply.
The bases on all of these chop saw models have
mounting holes (in the corners) through which
suitable bolts (not supplied) can be placed to
secure the machine.
Note: The S355CPSL has four mounting
holes and S355CPS and S380CPS have three
mounting holes.
Site the machine giving consideration to the
following guidelines:
• To avoid injury from flying debris, position
the saw so that other people or bystanders
cannot stand too close (or behind) it.
• Locate the saw on a firm, level surface where
there is plenty of room for handling and
properly supporting the workpiece.
• Ensure that the workbench or other
supporting structure is firm and stable and
does not 'rock' .
• Ensure that the power cord cannot become
entangled with any part of the machine
during cutting operations.
• Ensure that the power cord is routed in such
a way that it does not pose a trip (or any
other type) of hazard to the operator or
any bystanders.

TRANSPORTING THE SAW

Only transport these machines with the Cutting
Head in the locked down position (Fig. 1) and
the Locking Pin fully engaged in its socket.
UNLOCKING THE CUTTING HEAD
Note: We recommend that the operator keep
hold of the cutting handle throughout this
process to ensure a controlled transition of the
cutting head to the upper position.
• Gently press down on the Cutting Handle.
• Pull out the Locking Pin. (Fig. 2) Allow the
Cutting Head to rise to its upper position
(Fig. 3).
REMOVING OR INSTALLING A BLADE
WARNING: Only use genuine Evolution blades
designed for this machine - see page 12.
It is recommended that the operator considers
wearing protective gloves when handling the
blade during installation or when changing the
machines blade.
REMOVING A BLADE:
• Ensure that the Cutting Head is in its upper
position.
• Using the Hex Key supplied, loosen the front
arbor cover bolt and rotate the arbor cover out
of the way. (Fig. 4).
• Press the arbor lock button (labelled) (Fig. 5)
and use the supplied hex key to remove the
blade bolt. The blade may rotate slightly until
the arbor lock engages.
• Remove the arbor bolt, washer and outer
blade flange. (Fig. 6).
• Open the blade guard and carefully remove
the old blade. Leave the inner blade flange
in place.
INSTALLING A BLADE:
• Install the new blade, ensuring the directional
arrow on the blade matches the direction of
the arrow on the upper blade guard (Fig. 7).
• Allow the blade guard to close and refit the
outer blade flange and washer.
• Partially refit the arbor bolt, press the arbor
lock button and fully tighten with the supplied
hex key.
After replacing a blade, always run the machine,
without load to ensure the blade is seated correctly.
CUTTING ANGLE ADJUSTMENT
TO ANGLE THE REAR VICE JAW:
• Loosen the lever handle. (Fig. 8) The lever
handle is a spring loaded ratchet type. Pull up
the Lever Handle and reposition to continue
loosening.
Once the lever handle has been loosened (several
times may be necessary):
• Rotate the fence to the desired angle and
retighten the lever handle.
15
EN