JF 30P Manual Técnico De Operación página 13

OPERATION TECHNICAL MANUAL - FORAGE CHOPPER JF 30P
Electric Motor
1d
1f
NOTE: See required motor power on page 9.
2b
Install the motor on sliding rails (2d and 1f) and fasten it
with 4 bolts + plain washers + nuts (2b).
2b
NOTE: Fasten the nuts (2b) only after the adjustment
between pulleys and belts, according instructions
bellow:
Assemble the belts and the motor pulley: 5
a) Remove the cover (5) loosing the four nuts (2c).
b) Install the pulley (3) on motor axle with one key.
2c
c) Align the motor pulley (3) with the pulley (2d). If
necessary, move the motor forward or backward,
2d
according indicated by the arrows below.
3
d) Obtained the aligment, fasten the 4 nuts (2b).
2c
2b
1h
1h
A
See instructions below about pulleys aligment:
A - Proper Aligment.
B
Incorrect aligment:
B - Move the motor forward or backward.
C - Axles not parallel: adjust the nuts (1h) in the same
C
way.
13