ARIETE 1389A Manual De Instrucciones página 21

on the machine.
• Repeat the water dispensing operation making the pump run for about 15-20 seconds and then
let it rest for another 15-20 seconds until two tanks of water have been used.
• Remove the filter holder from the machine, remove the filter and rinse well under running water.
• Switch off the machine, unplug the power cord from the power outlet and wipe the filter holder
hooking seat with a sponge to remove any detergent residue from the spray.
• Restart the machine, attaching the filter holder again and still dispensing at least 2 cups of water
to complete rinsing.
If the coffee machine is used daily, it is recommended to carry out the cleaning operation at least
every three months.
Cleaning the silicone disc
Wash the silicone disc (C) under running water, bending it slightly on the sides in order to free the
centre hole of any residue of coffee grounds that could clog it (Fig. 14).
Cleaning the filter holder seat
With use, it may occur that in the filter holder seat there is a sedimentation of coffee grounds, which
can be removed with a toothpick, a sponge (Fig. 15), or letting water run through without fitting the
filter holder (Fig. 4).
Cleaning the Maxi Cappuccino device
Warning!
Perform the operation when the chrome-plated tube is cool to avoid
burns.
Unscrew the device (H) from the small pipe and wash it with running water. The small pipe can
be cleaned with a non-abrasive cloth. Screw the cappuccino maker back on as far as it will go. If
necessary, clean the small steam outlet hole again with a pin. After each use, dispense steam for a
few seconds to clear the outlet from any residues.
Tank cleaning
It is advisable to periodically clean inside the tank with a sponge or damp cloth.
Cleaning the grill and the drip tray
Remember to empty the drip tray from time to time (K).
Remove the grill (I) and wash it under running water; remove the tray (K) from the machine, empty
it and wash it under running water.
Cleaning the machine body
Warning!
Clean the fixed parts of the machine using a damp non-abrasive cloth
to avoid damaging the body.
DESCALING
Good maintenance and regular cleaning preserve and keep the machine efficient for a longer pe-
riod, greatly reducing the risk of scale formation into the appliance. If despite this, after some time,
the appliance operation should be compromised, due to the constant use of hard and very hard wa-
21