Technical Data; Installation; Mounting - Loctite Shot Miser 98116 Manual De Operación

3 Technical Data

®
Loctite Shot Miser
Pneumatic Supply
Quality
Control Air Connection
Compressed Air Usage
Product Pressure
Product feed line
Weight (less tubing & dispense needle) 228 grams (0.5 lbs.)
®
Loctite Shot Miser
Input Voltage / Cycles
Fuse
Size (width x depth x height)
Weight
®
Loctite 1 Liter Shot Miser
Pneumatic Supply
Size (width x depth x height)
Weight

4 Installation

Caution!
DO NOT REMOVE ANY ITEMS THAT ARE SEALED IN PLASTIC BAGS UNTIL
THEY ARE TO BE USED AS THEY MAY BECOME CONTAMINATED
RESULTING IN PERFORMANCE PROBLEMS.

4.1 Mounting

®
Secure Loctite Shot Miser
mm dia. screws. The hole pattern is given in Figure 2. Tighten the mounting screws to approximately 10-
inch pound torque.
®
Loctite 1 Liter Shot Miser
Notice
•
Always use wire stand to support the reservoir.
•
Never pour product directly into the reservoir
TM
Dispense Valve 98085
TM
Valve Controller 98079
TM
Reservoir 98090
TM
Dispense Valve (Part no. 98085) to a mounting surface with #10 dia. or 5
TM
Reservoir 98090
min. 30 psig, max. 70 psig
filtered to 10 µm, oil free, non-condensing
4mm (.157")
less than 1 scfm per stroke.
0 psig to 80 psig
6.3 mm (.250)
115VAC, 50/60 Hz
1 Amp, 250V, 5mm X 20mm, Fast Acting
6.1 inches x 6.9 inches x 3.9 inches
3.5 pounds
100 PSI maximum
8.5 inches x 8.5 inches x 13.25 inches
8.5 pounds