Air Filter - EMAK GS 371 Manual De Instrucciones

depth gauges and, if necessary, lower them using
the flat file and template supplied optional, then
I
round off the front corner (Fig. 26).
WARNING - Proper adjustment of the
GB
depth gauge is as important as proper
sharpening of the chain.
F
GUIDE BAR
The guide bars provided with a sprocket at
D
their tip must be lubricated with grease using a
lubrication syringe.
The bar should be reversed every 8 working
E
hours to ensure uniform wear.
Keep the bar groove and lubrication hole clean
using the bar groove cleaner supplied optional.
NL
Check the bar rails frequently for wear and, if
necessary, remove the burs and square-up the
GB
rails using the flat file.
Turn the guide bar and check that the lubrication
holes are free from impurities.
GR
WARNING - Never mount a new chainsaw
on a worn sprocket.
TR
AIR FILTER - Rotate the knob (A, Fig. 27) and
CZ
check the air filter (B) each day. Clean with Emak
degreaser p/n 001101009A, rinse with water
and blast dry with compressed air, not too close,
SK
blowing from the inside outwards. Renew the
filter if heavily clogged or damaged.
RUS
WARNING! – When refitting the air filter (B),
fit it into well, before reassembly.
UK
FUEL FILTER - Check the fuel filter periodically.
Replace it if too dirty (Fig. 28).
PL
OIL PUMP (automatic/adjustable) - Flow
adjustment is pre-set by the manufacturer. Oil
H
flow can be adjusted by the operator according
to specific requirements by means of the special
LV
adjusting screw (Fig. 32). Oil flow occurs only
when the chain is moving.
EST
WARNING - Never use scavenge oil.
STARTING UNIT - Use a brush or compressed
LT
air to keep the cooling louvers of the starter
assembly free and clean.
RO
ENGINE - Clean the c ylinder fins with
compressed air or a brush periodically.
Dangerous overheating of engine may occur
due to impurities on the cylinder.
34
SPARK PLUG - Clean the spark plug and check
the electrode gap periodically (Fig. 29).
Use CHAMPION RCJ7Y or of other brand with the
same thermal grade.
CHAIN BRAKE - If the chain brake does not work
properly, remove the chain cover and the clean
brake components. Replace the chain brake band
if worn or deformed.
Never use fuel for cleaning operations.
CARBURETOR
Before adjusting the carburetor, clean the
starter cover, the air filter (Fig. 27) and warm
up the engine. This engine is designed and
manufactured in order to comply with the
applicable (EU) 2016/1628 Regulations.
The carburetor (Fig.30) is designed to allow
adjustment only of screws L and H, through
-¼ turn. The range of adjustment allowed
by turning screws L and H through -¼ turn is
factory-set and cannot be chenged by the user.
WARNING – Don't try to force the screws
outside the range!
Idle screw T is adjusted in order to ensure a good
safety margin between idle running and clutch
engagement.
WARNING: With the engine idling, the chain
must never turn. If the chain moves to the
minimum, intervene on the T screw and reduce
the speed of the motor. If the problem persists,
immediately stop the work and contact an
Authorized Service Center to solve the problem.
Screw L must be adjusted so that the engine
promptly responds to sharp accelerations and
gives good idle operation.
Screw H must be adjusted so that the engine
gives maximum power during the cutting phase.
WARNING - Weather conditions and
altitude may affect carburation. Do not
allow anyone to stay close to the chainsaw
while working or while adjusting the
carburetor.
MUFFLER
WARNING – This muffler incorporates
a catalytic converter, needed in order