Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
CP 0077
Overview
To reduce the risk of serious injury or death
to yourself or others, read the Safety
instructions section found on the previous
pages of this manual before operating the
machine.
Design and function
CP 0077 sludge pump is intended for removing
water from trenches, ditches, and manholes. It can
also be used as an industrial pump at excavations,
wet drilling applications containing rock fragments,
pumping sea water, and for certain corrosive
chemicals. It is not recommended to pump any
liquid with a temperature above 212°F (100°C). No
other use is permitted. CP 0077 is adapted to meet
different demands in respect of flow(Q) and pressure
head(H) (see diagram below).
CP 0077 pump is not fully submersible, which means
that it can not be submersed into the pumped
medium, below muffler level. CP 0077 can easily
handle water containing solids of up to 15% of the
total mass. It can also easily handle solid particles
up to 1" (25 mm) in size without causing any
blockage. CP 0077 pump is self priming.
The diagram is valid at 6 bar (87 psi) and when
pumping from base plate level. Use of a suction hose
will decrease possible head.
H: Head feet (m)
Q: Flow imp gal/min (l/s)
NOTICE
The capacity of the pump will change
and the chart above will not be accurate if a suction
hose is used, if a lower air pressure than the
recommended is used, or if the pumped liquid has
a different viscosity than water.
9800 0556 90a | Original instructions
www.CrowderSupply.com • Toll Free: 888-883-5144
Safety and operating instructions
Main parts
Liquid intake
A.
Discharge outlet
B.
C.
Air inlet
D.
Air outlet
Oiler
E.
Muffler
F.
G.
Float
H.
Check valve
Control valve
I.
Ejector valve
J.
Ejector valve plug
K.
9
Publicidad
Capítulos
Tabla de contenido
