Before First Using This Appliance; How To Use This Appliance - Beem Mr. Tea Manual De Instrucciones

CAUTION – Material damage
29. Never transport the utensil when it is hot, and make sure it is empty before
transporting it.
30. The handles of the tank are only for transportation purposes.
31. Operate the appliance only on a horizontal, even surface. This base must be
heat resistant and sufficiently stable. Think about the overall weight of the
utensil when full.
Always make sure there is a safe distance to flammable parts.
32. The plug must be easily accessible so that you can pull it out quickly if
necessary.
33. Do not place the utensil on a base with a surface which is sensitive to water.
Splashing water or condensed steam could cause damage.
34. Never place the appliance near a gas flame, electric hotplate or other source of
heat. External heat can damage the appliance.
5.

Before first using this appliance

• Ensure that all packaging material has been removed from the appliance (protective
film, etc.).
• Under no circumstances remove the rating label or any warning labels.
CAUTION: check that the appliance is not damaged. If any parts are damaged,
do not use the appliance and contact a qualified service engineer.
• Place the appliance on a level, stable and heat-resistant surface. Do not place the
appliance beneath an overhanging cupboard.
• Clean the appliance and the accessories before using it for the first time. This will
remove any debris that might remain from the production process.
6.

How to use this appliance

• Remove the kettle from the base unit to fill it with water.
• Pour the required amount of fresh water (note the maximum capacity of 4.0 litres);
do not fill the water container past the fill level mark (9).
• Replace the steam cover and the teapot (5+7).
• Place the kettle onto the base unit (17). It can be placed in any position (360°
rotation).
• Ensure that the adjusting knob (16) is turned anticlockwise until it reaches its detent.
• Then insert the plug into the mains socket.
• Turn the adjusting knob clockwise to its detent. The thermostat allows stepless
adjustment of the degree of heat. You can choose between the settings: boil /
interval boil / hot / warm.
• If you turn the adjusting knob to the detent, the water will boil rapidly. If you leave
the adjusting knob in this position, the water will boil continuously until it eventually
all evaporates. In order to avoid this continuous boiling function, push the knob back
down until the signal light on the base unit goes out. Now the thermostat only
switches on again when the temperature of the water drops, heating it again. In this
way, the thermostat regulates energy supply in accordance with requirements, saving
a great deal of energy. The signal light switches on and off in the thermostat cycle.
BEEM – Elements of Lifestyle
Seite 19 / 100