Mettler Toledo IND560 Guia De Instalacion página 35

A. Open the enclosure per the instructions provided in the Opening the
Enclosures section.
B. Loosen and remove the two nuts securing the two grounding straps (that
also operate as hinges for the front cover) to the rear housing. See Figure
2-9.
Figure 2-9: Loosening the Ground Straps
C. Carefully rotate the front cover 180 degrees and reattach the two
grounding straps to the two studs near the grip bushings using the two
nuts removed in the previous step as shown in Figure 2-10. Tighten the
two nuts.
Figure 2-10: Reversing the Cover
4. Mark the position of the mounting holes on the vertical surface per the
dimensions shown in Figure 2-11 or by holding the terminal up to the surface
and marking through the bracket holes.
IND560 Installation Manual
Ground straps
Ground straps
2-7