GYS STARTIUM 330E Manual Del Usuario página 17

Translation of the original instructions
To use the «Automatic restart» mode :
- Perform steps 1 and 2 of normal loading.
- When starting the charge (step 3), press the START/STOP button ( - 9) for a long time (> 5 sec.). (
An indicator helps to check if the charge is indeed in «Automatic restart» mode :
- The voltage and percentage LEDs (4 and 5). They do not stay on but will blink.
In this mode, Press the START/STOP button to stop the charge. (
A power supply cut will not stop the charge from resuming.
b. TIMER feature
The TIMER feature (n°14) is used to set a charging time from 10 to 120 min (by steps of 10 min).
The charge when using the TIMER feature is manual. This has the following consequences :
- Whatever is the battery health status (sulfated, short circuited, voltage < 1V), the charge will always be
triggered.
- The charge starts even if the battery connection is faulty: clamps disconnected or in short circuit There
is a risk of sparks if the connection instructions are not observed.
To use the «TIMER» function:
- Perform step 1 of normal loading.
- In step 2, choose the charging rate (
with the selection button (
- The button (14) allows you to select the desired charging time from 10 to 120 min in 10 min steps.
- Press the START / STOP button (
Two indicators can help to check that the charge has started :
- The display (n°2). -It alternates between the battery voltage and the remaining time in minutes.
- The voltage and minutes LEDs (3 and 4). They remain on and alternate at the same time as the display.
The charge may be be stopped in several ways :
- At the end of the selected time.
- When there is a power supply cut
- By pressing the START/STOP button.
c. charging several batteries simultaneously.
It is possible to charge several batteries simultaneously by connecting them in parallel. The positive terminals connected
to the red clamp and the negative terminals connected to the black clamp. These batteries or battery groups must be
of the same voltage, 12V or 24V.
Charging batteries in series is not recommended.
USE IN STARTER MODE (INTERFACE, P.5)
Do not disconnect the battery fom the vehicle. Connecting the battery can lead to the vehicle's memory
loss and a potential impossibility to restart it.
1. Connection (p.15).
2. Press the selection button (
3. Start the preload by pressing the START / STOP button (
• The «START ENGINE» mode detects sulfated batteries and will thus refuse to start the vehicle. The
machine will automatically start the desulfating procedure in order to protect on-board electronics.
• If the battery is excessively damaged (e.g. sulfated), the charger will block the start. In this event, the
startium intermittently indicates « CIP » (Charge in Progress) and 0%. This means that battery recovery
is in progress. As long as «CIP» appears on the display, it is not possible to start the vehicle.
Make sure to follow the recommended precharge time, depending on the battery capacity.
STARTIUM 330E / 480E / 680E / 980E
- 13) while respecting the battery capacity. Then select the «TIMER» function
- 12).
- 9) to start the charge.
- 13) until you reach the START ENGINE mode (1).
- 9).
- 9).
EN
- 9).
17