Standby Mode; Programming - Redexim SPEEDSEED 1100 Manual Del Usuario

UNIVERSAL COUNTER UC 300
the residual autonomy of the UC 300 before it turns off completely is limited and will
depend also on use. If the battery runs down completely and the UC 300 turns off,
some of the data may be lost (refer to the previous section); to charge the battery,
connect the cable with the jack connector (provided) to a 12V battery: Do NOT use
car battery charging devices. The charging process generally takes about 10
hours, while the autonomy between a charging cycle and the next is about 2.5 years
(although this depends on the extent and conditions of use); it is not necessary for
the speed sensor to be connected while the battery is charging.

7. Standby mode

To save on energy and increase the autonomy of the batteries, the UC 300
automatically goes into standby after 5 minutes if it does not receive any pulses from
the speed sensor and none of the buttons are pressed. In standby mode, power
consumption is less than 30µA and the last data remains on the display without any
other information. The UC 300 exits standby mode when the next pulse is received
from the speed sensor or when you press any button for at least 1 second.

8. Programming

As with the totalizers, either metric or imperial units of measurement can be used for
the programmable speed and area parameters. To access the programming phase
with the UC 300 turned on, press the "Prog" button for 3 seconds and five horizontal
dashes appear on the display. The first programmable parameter, "Un", then
appears as shown below;
UC 300 UC 300 UC 300
+ - + - + -
Km/h
- - -
Prog. Prog. Prog.
Reset Reset Reset
Sel ect Sel ect Sel ect
3"
Prog.
During the programming phase, you can use the "+" and "-" buttons to edit the value
of the parameter, then press the "Prog" button to confirm your changes and move on
to the next parameter;
10